15
Manual operation
Deleting stored values from memory
• Ensure that you no longer need any of the measurements
stored in the uCheck Smart’s memory before you delete
them.
• To delete entire stored memory readings, press and hold the
[ ] ‘Memory’ button till the screen shows ‘CL’ and the
‘ ’ icon.
• Release the [ ] ‘Memory’ button and ‘CL’ will begin to
flash. Press the [ ] ‘Memory’ button again immediately
and ALL stored readings would have been deleted.
Note: You CANNOT delete any particular measurement.
When you do not want to store a reading
• Right after the measurement, while the reading is still being
displayed, press and hold [ ] ‘ON/OFF’ button till the
‘ ’ icon in the LCD screen is flashing and release the
button.
• Press the [ ] ‘Memory’ button and ‘CL’will display on the
LCD screen (it will flash only once and disappear).
• Your last measured result will not be recorded.
To Next Page
Loading...