Operating Frequency – If the current configured Regulatory Domain allows manual frequency
selection configure the frequency wlan interface operates on. If the Regulatory Domain requires
auto channel selection then DFS (Dynamic Frequency Selection) is shown here.
Channel Width – Channel width the device is configured to operate. Available values are 20
MHz (standard width), 10 MHz (half width), 5 MHz (quarter width) and 40 MHz (802.11a Turbo
mode).
WLAN Inter Client Traffic– Choose whether direct relaying of traffic from wireless clients
connected to this wireless interface to other wireless clients connected to this wireless interface
should be enabled or disabled.
Data Encryption – Enable or Disable over the air OSBRiDGE proprietary data Encryption here.
This encryption scheme only works between compatible OSBRiDGE devices.
Supported Data Rates – Enable or Disable WLAN Data Rates the OSBRiDGE 5G device should
support when communicating with client devices.
To Next Page
Loading...