Oslo OSP1-10 - User Manual

Questions and Answers

D
David FarrellAug 13, 2025
Why is my Oslo OSP1-10 Air Conditioner not cooling properly?
- D
  David ChristensenAug 13, 2025
  There could be several reasons why your Oslo Air Conditioner isn't cooling well. Direct sunlight, open doors or windows, a crowded room, or other heat sources can affect its performance. Try closing curtains, doors, and windows, removing extra heat sources, or adding more air conditioners. A dirty filter or a blocked air inlet/outlet could also be the cause. In that case, clean or replace the filter, and remove any obstructions.
T
Tina HallAug 16, 2025
What to do if my Oslo OSP1-10 Air Conditioner remote control does not work?
- G
  George ReynoldsAug 16, 2025
  If your Oslo Air Conditioner remote control isn't working, first, try moving closer to the air conditioner, ensuring you're aiming at the signal receptor on the unit. Also, replace the batteries, as they might be depleted.
M
Mark BallAug 20, 2025
How to fix Oslo Air Conditioner that fails to start up?
- T
  Todd WardAug 20, 2025
  If your Oslo Air Conditioner doesn't start, ensure it's connected to a working power socket and turned on. Also, check if the 'Water-full' icon is lit, indicating the unit needs to be drained. The unit is recommended to be used between 8-35 degrees. Finally, if in cooling mode, the room temperature might be lower than the set temperature, or in heating mode, the room temperature might be higher than the set temperature. Try adjusting the set temperature accordingly.
D
Dawn RodriguezAug 25, 2025
What to do if Oslo OSP1-10 displays “E4” code?
- M
  Michael RothAug 25, 2025
  If your Oslo Air Conditioner shows an “E4” code, it indicates anti-freeze protection is active. The unit should automatically restore its functions once the anti-freeze protection cycle is complete.
K
Kimberly HallAug 28, 2025
Why does my Oslo OSP1-10 have a high noise level?
- W
  wandrewsAug 28, 2025
  A high noise level in your Oslo Air Conditioner could be due to the unit being placed on an uneven surface. Try placing it on a flat, firm surface to reduce the noise.
M
Michael LeeSep 1, 2025
What to do if Oslo Air Conditioner displays “E2” code?
- T
  Tracy MarshallSep 1, 2025
  If your Oslo Air Conditioner displays an “E2” code, this indicates a room temperature sensor failure. In this case, you should check the room temperature sensor and related circuits.
C
christiansanchezSep 4, 2025
What to do if Oslo Air Conditioner displays “E1” code?
- G
  gwongSep 4, 2025
  If your Oslo Air Conditioner displays an “E1” code, it means there is a tube temperature sensor failure. Check the tube temperature sensor and related circuits.
B
Brian RothSep 8, 2025
Why the compressor does not work in Oslo OSP1-10?
- M
  melissa61Sep 8, 2025
  The compressor in your Oslo Air Conditioner might not be working due to the initiation of overheat protection. Wait for the temperature to decrease, and the unit will restart automatically.