2.7.2 Measurement start. When pressurized to stop blood ow, the Blood Pressure
Monitor stops pressure before automatically leaking air and automatically
measuring blood pressure.
The heartbeat symbol flashes once a pulse is detected.
When the heart beat symbol appears and ashes, the Blood Pressure Monitor
detects the pulse and begins to calculate the pulse automatically.
2.7.3 The blood pressure and pulse rate are displayed when the measurement
completed.
The cu is deflated automatically, and all of the measurement results are stored in
the memory.
The “ ” symbol will be displayed if irregular heartbeat is detected.
2.7.4 Press the “START/ STOP” button to turn off the unit.
The unit will be automatically turned o after two minutes if no more operation.
NOTE: The ination or measurement can be stopped by pressing the “START/
STOP” button at any time.
2.8 Use the Memory function
The unit stores the blood pressure and pulse rate in the memory after
completing a measurement each time. 2x120 sets of measurement values can
be stored automatically.
The earliest record will be deleted automatically to save the latest measurement
value when more than 2x120 sets.
The unit also calculates an average reading based on the values of the latest 3
times measurement .
To Next Page
Loading...