Precision Trimmer Instructions
How To Use
Pull the old shaver head assembly out of the shaver.
(drawing) (Fig 13).
Insert the new shaver head assembly inside the groove (1)
on the shavers top and then press down the shaver head
assembly (2) to mount it on the shaver (a click will be
heard). (Fig 14)
1.
2.
Ensure that you comb your hair according to hair growth
direction before clip hair.
Put on the comb accessories to the slot both sides till you
hear the sound, make sure the comb accessories have
already fixed on both sides. (Fig 16)
The comb accessories have two length "3MM and 6MM" for
clip hair with different length. Replacing the comb
accessories directions according to length mark in the
bottom. (Fig 17). Put down the comb accessories from one
side slot to another. (Fig 18).
Open the switch, use it above the hair slowly. For good clip
effect, please use the product in a different direction from
hair growth direction.
Turn of the shaver power, remove the shaver head. Insert the
hair clipper into the slot of the top shaver.
Press down the hair clipper head part to install the shaver
body. (hear the sound like "kaca") (Fig 15)
TRIMMER
Note: Make sure your hair is clean and dry. Do not use the
product for wet hair.
1.
2.
3.
4.
To Next Page
Loading...