ATMOS / AURA AG
TM
SERIES
6
SIZING / FIT
ADJUSTING HARNESS
65L / 50L
A Completely loosen the pack's load lifters and harness straps.
B Locate the harness adjustment cams on the left and right side behind the fabric wing where the
yoke wraps around the edges of the backpanel.
C Push both cams down at the same time with your thumbs from the top of the harness attachment
point to open and release the cams. While pushing down on the cam with your thumbs, use your
index and middle fingers to grab the lower portion of the fabric wing in front of the cams.
D With the cams released simultaneously, slide both sides of the harness up or down to your desired
location based on your torso fit needs and release the cams.
E Ensure the cams are lined up at the same height by comparing each side’s position using the line
markings printed on the backpanel behind the suspended mesh. If they are uneven, release and
adjust one side’s cam to match the other.
F Follow "Harness Sizing" instructions to determine if the torso fit is correct.
FIT-ON-THE-FLY™ HIPBELT
65L / 50L
The-Fit-on-the-Fly™ hipbelt pad extends up to 6”/15 cm to accommodate different
hip sizes and provide a custom fit. To adjust the hipbelt:
A Locate the adjustment icon on the hipbelt and slide a hand between the fixed
hipbelt and the adjustable pad to separate the hook and loop closure.
B Slide the adjustable pad into position so that it wraps around your hipbones.
C Press firmly to re-engage the hook and loop closure.
D Extend the pads the same distance on both hipbelt wings so the pack weight is
distributed evenly.
Once adjusted, clip the hipbelt buckle across your hipbones and tighten.
To Next Page
Loading...
Need help?
General
