Osram OTi30W - User Manual

To Next Page

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. This product is for use with an LED lighting load and supplies up to 10W of power at factory

programmed current with a voltage between 10.0 VDC and 55.0 VDC in emergency mode for

a minimum of 90 minutes.

2. Make sure all connections are in accordance with the National Electrical Code, Canadian

Electrical Code and any local regulations.

3. To reduce the risk of electric shock, disconnect AC power of the emergency driver and fuse

from fuse holder of the battery pack before servicing.

4. This emergency driver is suitable for factory and field installation. For field installation, please

see the instructions on page 3.

5. This product is suitable for damp locations where the driver case temperature is 75°C maximum

and battery pack case temperature is 55°C maximum.

6. Do not use for outdoor applications.

7. Product is not suitable for heated air outlets and wet or hazardous locations.

8. Do not install near gas or electric heaters.

9. The use of accessory equipment not recommended by the manufacturer may cause an unsafe

condition.

10. Do not use this product for other than intended use.

11. Equipment should be mounted in locations and at heights where it will not readily be subjected

to tampering by unauthorized personnel.

12. Servicing should be performed by qualified service personnel.

13. Use caution when servicing batteries.

SAVE THESE INSTRUCTION

THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM

BATTERY. THE BATTERY MUST BE RECYCLED OR DISPOSED

PROPERLY.

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD

ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:

OTi30W Self Test Slim Emergency Driver

Installation and Troubleshooting Guide - PN: 57414

Main Page

Need help?

Do you have a question about the Osram OTi30W and is the answer not in the manual?

Summary

Important Safeguards

Safety Instructions

Essential safety precautions for using electrical equipment and following all instructions.

Operating Modes

Normal Mode Operation

Driver function when AC power is applied and batteries are charging.

Emergency Mode Operation

Driver function when AC power fails, operating the LED load.

Self-Testing Operation

Test Switch

Installation Instructions

Critical Installation Warnings

Critical safety warning regarding battery connection sequence during installation.

Load Compatibility Checks

Ensure LED load power, current, and voltage match driver limits for safe operation.

Output Current Programming

Details on programmable output current and where to find information.

Wiring the Emergency Driver

Wiring Diagram for Non-Switched Line

Illustrates wiring connections for the emergency driver with a non-switched line.

Wiring Diagram for Switched Line

Illustrates wiring connections for the emergency driver with a switched line.

Maintenance and Troubleshooting

Maintenance Procedures

Routine testing and checks of the emergency driver's indicator light.

Troubleshooting Guide

Table of status indicators, problems, and corrective actions for the emergency driver.