dark place leaving the lid slightly open. (Exposure to sunlight and
extreme heat may damage hoses and unit.)
• When reusing the unit after storage, fill the reservoir with clean water
and turn the pump on to circulate the water through the hoses and
flush the remaining water mixture out of the system (use old pad for
this procedure, discard the pad after cleaning is completed).
• Dispose water and refill the reservoir with fresh ice and water
combination to begin cold therapy treatment. Follow operating
instructions - before each use.
• Before you use the unit, inspect hoses and new pad for any tears or
breaks. Contact your healthcare provider to obtain new Cold Rush
pad.
• Clean or replace insulation barrier as recommended by your
healthcare practitioner.
ENVIRONMENTAL
• Operating Temperature: +°C to °C
• Operating Humidity: % - % Relative Humidity
• Atmosphere Pressure: h Pa – h Pa
• Shipping and Storage Temperature: -°C to °C
• Shipping and Storage Humidity: % - % Relative Humidity, non-
condensing
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
The device is intended for use in the electromagnetic environment specified
below. The customer or user of device should assure that it is used in such an
environment.
Emissions Test Compliance
Electromagnetic Environment –
Guidance
RF Emissions CISPR Group The device uses RF energy only for
its internal function. Therefore, its
RF emissions are low and are not
likely to cause any interference in
nearby electronic equipment.
RF Emissions CISPR Class B The device is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low voltage
power supply network that supplies
buildings used for domestic
purposes.
Harmonics Emissions
IEC --
Class B
Voltage Fluctuations/
Flicker Emissions
vIEC --
Complies
To Next Page
Loading...
Need help?
General
