4
TIGHTENING THE CONTAINER
A. To tighten container bottom, put
assembled container securely into motor
base ring with handle and lug in front of
the right stop.
B. Using the container handle, turn container
to the left as far as possible. This insures
that the container bottom is tightened
properly. Remove container from motor
base and mount.
C. To operate Blender, place assembled
container in motor base ring with container
lug against flat side of the motor base
stop. If container lug does not rest against
flat side of right stop, remove container
assembly and place against flat side of left
stop. Seat container firmly and operate.
D. To remove container, lift straight up.
(If it is not easily removed, rock gently
and lift up, do not twist). If container
bottom cannot be loosened by hand,
place assembled container into motor
base ring with handle in front of left side
stop. Using handle, turn container to right
until container bottom loosens.
Do not attempt to place the container on or
attempt to remove it from the motor base
while the motor is running.
ALWAYS HOLD CONTAINER WITH ONE
HAND WHILE PROCESSING!
ASSEMBLING YOUR BLENDER
CAUTION: Follow these important steps to assemble, tighten and mount Blender container
quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE EXPOSED.
1. 2. 3. 4.
1. Turn container upside down so the small
opening is at the top.
2. Place sealing ring on container opening.
3. Turn the agitator blades upside down
and place in mouth of container.
4. Thread container bottom to container.
A B
C D
Right
Stop
Container
Lug
Left
Stop
Motor
Base
To Next Page
Loading...
