English-7
OPERATING INSTRUCTIONS
FILLING THE WATER RESERVOIR
a. Fill the water reservoir with water (see gure 1). You
may use either a jar to ll it up or remove it from the unit
and then ll it up under the tap. Fill the reservoir with the
desired amount of water below the “MAX” level on the
reservoir. Never use warm or hot water to ll the
water reservoir.
a. Close the water reservoir lid. If you have removed it from
the unit to ll up with water, please make sure to place it
back tightly in its place.
FILLING THE MILK RESERVOIR
If you plan to prepare a cappuccino or latte, remove the milk
reservoir from the unit by lifting up on the milk reservoir release
button, simultaneously sliding milk reservior out, grabbing
milk reservoir by the lid (see gure 2). Then, pour the desired
quantity of cold milk you estimate you will need, making sure it
is below the “MAX” level on the reservoir (see gure 3). Once
nished, slide the milk reservoir back onto the unit ensuring it
ts tightly. You should feel the milk reservoir lock in place.
NOTE: You can use any type of milk you prefer, i.e. whole milk,
low fat milk, organic or soy milk
.
CHOOSING THE PORTA-FILTER
Your unit includes two porta-lters, one for use with ground
coffee and E.S.E. pods and another one for use with
OriginalLine Nespresso
®
* capsules.
USING THE PORTA-FILTER FOR GROUND COFFEE AND E.S.E PODS
CHOOSING THE FILTER
Select the lter to be used as follows:
a. FOR A SINGLE SHOT – use the lter for a single shot of espresso if using ground
coffee, or if using E.S.E. (Easy Serving Espresso) pods.
POD
b. FOR A DOUBLE SHOT OR TWO SINGLE SHOTS – use the lter for a double shot
of espresso. By placing two small cups underneath the porta-lter, you may prepare
two single shots of espresso at once.
NOTE: The pod lter included with your unit has been designed to work only with
E.S.E. (Easy Serving Espresso) (45 mm) pods.
Figure 3
Figure 2
Figure 1
To Next Page
Loading...
