Oster BVSTEM7400 - Page 45

Before First Use
Use below information to help with the  rst time set up.
1. Wash & Dry Parts
5. Insert & Set Bean Hopper
7. Prime Machine
6. Remove Red Plug, and set up Water Reservoir
2. Insert Top Burr 3. Drip Tray & Accessories Storage Tray 4. Start Up
Wash the Milk Jug, Filter Baskets,
Porta lter, Bean Hopper, Top Burr,
Tamper and Water Reservoir in
warm water with a mild detergent.
Rinse and allow thorough air
drying.
Insert & turn Hopper to set Grind Setting. As a
starting point try Grind Setting 15.
Insert Two Cup Filter
Basket into Porta lter.
Insert Porta lter into
Group Head, turn to
centre.
Press TWO CUP
BUTTON. Allow water
to run through until it
stops.
Turn DIAL to STEAM
and run for 20 sec.
TWO CUP
FRESH
GRIND
SETTING
2. TURN
1. ALIGN & INSERT
Fill with roasted coffee
beans.
Remove the red plug at the bottom of the water
reservoir and safely discard. Place the charcoal
 lter into the holder and insert it into the reservoir.
Fill reservoir with water and install.
Note: For further Grind Setting adjustment see Extraction Guide.
Note: Turning Porta lter might be tight for  rst few uses.
Use the handle to in-
sert Top Burr, rotating
clockwise to lock.
Assembly of drip tray and accessory tray
into position.
Plug in at socket. Flick
power switch downwards,
the switch will return
to centre. Indicator light
will pulse during heat up.
English - 8
BVSTEM7400_23PEM1_PORT/ENG.indd 8BVSTEM7400_23PEM1_PORT/ENG.indd 8 2023/11/28 10:502023/11/28 10:50