Customisable - Extraction Temperature
You can adjust the water temperature used for
espresso extraction, in 2°C increments, to cater
for different types of roasted coffee beans and for
personal preference.
• Adjusting Extraction Temperature
- Starting from the READY state,
press & hold the MANUAL BUTTON
for 3 seconds. The MANUAL
BUTTON light will beep and the light
begins to pulse.
The current programmed preset temperature will be
displayed.
Note:
The MANUAL LIGHT will continue to
pulse to indicate you are in a custom mode.
The temperature can be adjusted in 2 degrees C
increments:
- Press the double shot button to
increase temperature.
- Press the single shot button to
decrease temperature.
- The Extraction Timer will display the corresponding
temperature.
- To save the selected temperature
press the
MANUAL BUTTON.
Customisable - Extraction Pre-Infusion Profile
You can select from three Pre-infusion Profiles to
cater for personal preferences.
- Gentle Pre-infusion: Small defined
amounts of water are introduced
into the tamped coffee grinds, gently
adding moisture to bloom the coffee
grinds in preparation for a steady
water flow. For a balanced tasting
espresso. This is the default profile
setting.
- Distinct Pre-infusion: A single
distinct dose of water is released into
the tamped coffee grinds, followed
by a brief rest period, then a steady
water flow. For a more bright tasting
espresso.
- Constant Pre-infusion: Delivers
a constant, steady water flow from
start to finish. For a more sharp
tasting espresso.
Access Pre-infusion Custom Mode
- The Perfect Brew Máxima Espresso Maker is ON
and in the READY state.
- Press and hold the single shot button
for 3 seconds. The machine will beep
and the single shot indicator will begin
to pulse.
FINE TUNING YOUR ESPRESSO
English - 23
BVSTEM7400_23PEM1_PORT/ENG.indd 23BVSTEM7400_23PEM1_PORT/ENG.indd 23 2023/11/28 10:502023/11/28 10:50
To Next Page