• Cleaning & Unblocking Bottom Burr and Grind
Chamber
- Use the Cleaning Brush or a Vacuum Cleaner
to thoroughly clear the parts and surfaces in the
Grind Chamber of fine coffee grinds. A damp cloth
can be used to wipe the inside of the Grind Collar.
- Allow thorough air drying.
CAUTION: Do not pour water or any other liquid
into the Grind Chamber.
• Cleaning & Unblocking Grind Outlet
- Feed the Cleaning Brush up into the Grind Outlet
from below, wiping & brushing the inside surfaces.
- If the Grind Outlet is clear the bristles will be
visible inside the Grind Chamber.
• Replace Top Burr
- Identify the locking fixtures on the underside of
the Top Burr, underneath the moulded padlock
symbols.
- Using the handle insert the Top Burr into the
Grinder Collar, ensuring locking features align.
- Rotate the Top Bur approximately 30 degrees
clockwise to lock, the burr should click into
position.
- When correctly seated, the Top Burr will be flush
with the surface of the Grinder Collar.
Replace Bean Hopper
- Ensure the Hopper Guide is aligned, and the tab
on the Hopper base locates into the cut-out on the
rear of the housing.
- Align & insert the Bean Hopper into the Grinder
Collar and firmly pushing down turn clockwise to
lock into place and open the Hopper Guide.
- Reset to the Grinder Setting noted prior to
cleaning.
- Refill the Bean Hopper with coffee beans.
1. ALIGN HOPPER GUIDE
2. INSERT
3. TURN
Note: We strongly advise not to use Torrefacto
style coffee beans in your PERFECT BREW
MÁXIMA Espresso Maker. Due to the high sugar
content, the burr grinder assembly will quickly
clog.
CARE AND CLEANING – GRINDER
English - 33
BVSTEM7400_23PEM1_PORT/ENG.indd 33BVSTEM7400_23PEM1_PORT/ENG.indd 33 2023/11/28 10:502023/11/28 10:50
To Next Page