Oster OD20 - Operating Instructions; Turning Unit On;Off and Modes

English - 5
Turning the unit on and off
1. Plug the unit into a suitable electrical outlet.
2.Inthestandbystate,pressthepowerbuttontoturnon,theoperationindicatorlights
up and the default fan speed is high, the LED shows ambient humidity.
3.Toshutdown:Inthepower-onstate,pressthepowerbuttontoturnoff,therunning
indicator light goes off and the compressor stops immediately, and then the fan will
shutdownafter30seconds.
Protection and auto shutdown of the tank when it is full of water
Once the unit is on, press the Automatic button .Whenthewatertankisfull,thewater
tankfulllight will come on and the unit will turn off automatically. This indicates that it
istimetoemptythewatertankbeforeusingtheunitagain.Oncetheemptywatertankis
backintheunit,itwilltake3minutesbeforethedehumidifyingcompressorrunsagain.
Thisisaprotectionfeature.Ifyouwanttorestarttheunitwithoutwaiting,unplugitfrom
the outlet and plug it in again.
Protection against dripping water
Whenthewatertankisremovedtoemptyit,thisdevicestoresthecondensedwaterthat
continuestodrip.Oncethewatertankisbackintheunit,itwillreleasethatwaterintothe
tank.
Auto mode
Whentheenvironmentalhumiditysetis≥+3%,thefanstartsworkingandcompressor
startsworkingafter3seconds.Whenenvironmentalhumidity≤sethumidity-3%,the
compressorstopsworkingandfanstopsworkingafter30seconds.Bothfanspeedand
humidity can be adjusted under auto mode.
Sleep Mode
Touch the sleep button , the button lights up and the sleep function will be activated.
Pressandholdthesleepbuttonfor3secondstoresetthelter.
Timer
Press the timer buttontosetthe0-12hourtimingfunction.Theintervalis1hour.
Each time you press this button, the value increased 1 hours and then the corresponding
timingvalueisdisplayedonthescreen.Thesettingvalueis“00”tocancelthetimer
function. The indicator turns out. After the timer is set and completed, the timer LED is on
during the timing period. After the timing is over, the timer LED turns off automatically.
Intherunningstate,setthetimetoturnoffthemachine;
in the standby state, set the time to turn on the machine.
Speed
Only in automatic mode, touch this button to switch between high and low fan speed, and
the indicator light is on
OPERATING