Oster SUPER BVSTEM8100 - Page 44

English-18
Cleaning the automatic milk dispensing system
Note: it is important to do this daily to make sure the automatic milk frother works
properly.
1. Place a cup under the spout.
2. Fill the milk container with fresh water.
3. Connect the milk container to the espresso maker as described in “Preparing Latte”
section
4. Press the “Manual Clean” button.
5. The espresso maker will dispense hot water and steam to wash the dispensing tube
and milk spout.
6. Press the button again to stop the water.
7. Take apart the milk dispensing system by following procedure. Clean them with fresh
water.Theninsertthemilkdispensingsystemintoslot.(seeguresbelow)
Step 1: Remove the spout cover and then take out the milk dispensing system.
Step 2: Take apart the milk dispensing system into two parts and rinse with clean water.
Step 3: Assemble the milk dispensing system back to its original placement.
Step 4: Insert the milk dispensing system to the slot.
BVSTEM8100_23PEM1 (LA).indd 18BVSTEM8100_23PEM1 (LA).indd 18 2023/7/7 09:242023/7/7 09:24