OTIS DO3000 - Page 31

User’s Guide of DO3000 Door Operator
Lead the green future All rights reserved © OTIS 31/48
DOOR-Menu
Drive =3
Run comand source
old: 0 new:
Press to return.
Enter the menu M3312, press
GO BACK
GO ON
to select the following parameters:
DOOR-Menu
Drive =3
Feedback mode
old:1 new:
If this value is not 0, set it to 0, and press +
E N T E R
C L E A R
to confirm
DOOR-Menu
Drive =3
Feedback mode
old:0 new:
Press to return to main menu, enter the menu M334:
DOOR-Menu
Drive =3
Lift will learn
“CLEAR”Escape
Press +
E N T E R
C L E A R
to start learning; start interface of learning is as follows:
DOOR-Menu
Drive =3
Width : 000000
Door is learning
Operating process of door at learning:
close→close arrive→open→open arrive→close→close arrive
End interface of learning is as follows: