Troubleshooting Guide
Otolift Line
www.otolift.com
Try to run the lift in the UP direction:
Technician Required. Please call your local dealer:
Try to run the lift in the DOWN direction:
The lift is switched on and is ready to go.
The lift is moving up. The lift is
operated by the Joystick or Remote
Control.
The lift is moving down. The lift is
operated by the Joystick or Remote
Control.
The lift is switched off.
1. Check that the KeySwitch is on.
2. Check that the Power ON/OFF Switch is on.
Lift has arrived at the top of the rail.
Lift has arrived at the bottom
of the rail.
The lift is not charging.
1. Check the Charger is switched on.
2. If Hinge model, make sure lift is parked.
There is an obstruction on the
upside foot-rest edge. Check
footrest is clear.
There is an obstruction on the
downside footrest edge or underpan.
Check footrest is clear.
There is no power to the lift.
1. Check that the Charger is switched on.
2. Check that the Power ON/OFF Switch is on.
There is an obstruction on the drive
unit cover. Check that the cover is
clear.
There are multiple calls present, i.e.
a Remote Control is pressed at the
same time as the Joystick.
There is an obstruction on the drive
unit cover. Check that the cover is
clear.
There are multiple calls present, i.e.
a Remote Control is pressed at the
same time as the Joystick.
The downside arm is not lowered into position.
The Holding Switch is activated.
Check the switch on the arm.
The seat is in the swivelled position. Return the
seat to the travel position.
The Hinge is open. The folding rail section is not
in the down position. Only on Hinge model.
LIFT
READY
MOVING
UP
MOVING
DOWN
TILTED
ARM
OFF
CHARGE
AND
BEEPING
UP
FOOTREST
DOWN
FOOTREST
SEAT
SWIVEL
BATTERY
CRITICAL
MOTOR
FAULT
BRAKE
FAULT
RELAY
FAULT
OVER
CURRENT
SWITCHED
OFF
ARRIVED
TOP
ARRIVED
BOTTOM
HOLDING
SWITCH
UP
CHASSIS
MULTIPLE
CALLS
DOWN
CHASSIS
MULTIPLE
CALLS
HINGE
OPEN
OVER
SPEED
FINAL
LIMIT
SERVICE
DUE
THERMAL
CUTOUT
Have a look at the arm display.
What does it say?
To Next Page
Loading...
