PRODUCT INFORMATION
PULL-FORCE MEASUREMENT SYSTEM POWER-CHECK 2
2 PRODUCT DESCRIPTION
2.1 FUNCTION
The pull-force measurement system Power-Check 2 measures the pull-force in power drawbars.
The exchangeable adapter allows the use with steep taper and HSK systems.
The pull-force measurement system is embedded in the tool holder. The force occurring after the
clamping process is logged by the measurement system.
The measured pull-force is read from the display during manual operation. In addition, the measured
value is stored internally and may be logged by an adequate reading device (USB interface).
During automatic operation, the use from a tool magazine is possible. If the measurement device is
automatically transported into the clamping unit, the internal motion detector switches the device from the
standby into the operational mode. This ensures a long battery life. The measured pull-force is stored
internally and can be logged with an adequate reading device (USB interface).
The wireless version sends the measuring value to the receiving device.
POWER-CHECK-2_PE_2015-09
Subject to modification due to technical advance! // 6
Display
To Next Page
Loading...