OTT PLS - Scope of Supply; Order Numbers

4
1 Scope of supply
䊳
– 1 pressure probe with ceramic, capacitive relative pressure measuring cell and
plug-in, shielded, pressure probe cable with pressure compensation capillary
and Kevlar core for length stabilization. Pre-fabricated cable end with trans-
port protection against moisture. Optionally with 4 … 20 mA or RS-485 inter-
face (SDI-12 protocol)
– 2 protective caps (for covering the contacts when the plug-in connection is
separated)
– 1 operating instructions
– 1 supplement to operating instructions
– 1 factory acceptance test certificate (FAT)
2 Order numbers
䊳
OTT PLS pressure probe with 63.037.002.3.0
plug-in pressure probe cable
Required ordering information
– Measuring range: 0 … 4 m;
0 … 10 m;
0 … 20 m;
0 … 40 m;
0 … 100 m
– Cable length: 1 … 200 m
– Interface: 4 … 20 mA;
RS-485 (SDI-12 protocol)
䊳
Pressure probe 63.037.020.9.2
individual, without "pressure probe cable with connector";
Required ordering information
– Measuring range: 0 … 4 m;
0 … 10 m;
0 … 20 m;
0 … 40 m;
0 … 100 m
– Interface: 4 … 20 mA;
RS-485 (SDI-12 protocol)
Pressure probe cable with connector 63.037.021.9.2
Can be used universally for all measuring ranges/
interfaces. Required ordering information
– Cable length: 1 … 200 m
O-ring 0.926010.239
Protective cap 99.820.002.9.5
Replace -
ment parts
OTT PLS
plug-in type
OTT PLS
plug-in type