Need help?Do you have a question about the OTT PLS and is the answer not in the manual?
General| Brand | OTT |
|---|---|
| Model | PLS |
| Category | Test Equipment |
| Language | English |
Provides crucial safety warnings and guidelines for using the OTT PLS.
Instructs on connecting the OTT PLS to a datalogger via the SDI-12 interface.
Guides on connecting the OTT PLS to a datalogger via the 4-20 mA interface.
Explains how to determine the maximum load resistance for the 4-20 mA interface.
Lists and explains standard SDI-12 commands relevant to the OTT PLS.
Details commands for concurrent measurements in SDI-12.
Explains commands for performing system tests with the OTT PLS.
Covers commands to set or read units for level and pressure measurements.
Details commands for setting or reading temperature units (°C/°F).
Explains commands to set or read local gravitational acceleration for accurate measurements.
Covers commands for setting or reading average water density, useful for brackish water.
Details commands to activate or deactivate depth measurement mode.
Lists potential causes and solutions when the sensor doesn't respond to SDI-12.
Troubleshoots issues where the 4-20 mA loop current is absent.
Addresses problems with inconsistent or missing measured values.
Explains how loop current indicates operational states and faults for the 4-20 mA interface.
To Next Page
