6 | Ottobock
Finally, let the silicone bonding agent dry for about 1 hour. Insert, from inside,
a 5X118 dust lter into the hexagon socket of the valve (Fig.7).
In case of Botta cosmetic covers or cosmetic covers coated with Superskin
the 502Z24=M10 knurled nut can be sealed in place on the socket.
Attention: Make sure that the 5X115 One-Way Valve does not come
in contact with resin.
If it is necessary to change the valve, unscrew it from the socket using a
4 mm allen wrench.
5 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of
this document, particularly due to improper use or unauthorised modication
of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classied as a class I device
according to the classication criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
To Next Page