Outback S-Lite User Guide 3 PN 875-0194-000 Rev D1
Safety
pressure, and contaminated hydraulic fluid. Outback S-Lite may not perform as
intended on a vehicle that is not properly maintained. Errors in vehicle performance
while following Outback S-Lite guidance increase the risk of operator and bystander
injury or death.
Turn off the vehicle and disengage the Outback S-Lite when installing or performing
maintenance.
Before attempting to install any Outback S-Lite components, park the vehicle on a
clean level floor with adequate clearance to work all around. Use an appropriate
ladder or platform when installing or performing maintenance on cables, the antenna
and other components of the Outback S-Lite.
Before you perform any drilling, cutting or fastening, ensure that no other vehicle
components, such as electrical wiring, will be damaged. Failure to follow this warning
may cause physical injury and/or damage to the machine.
To avoid burns or electric shock injury when installing or removing the Outback S-Lite,
do not touch parts of the vehicle that are heated or electrically energized.
Mounting the Console
Mount the Outback S-Lite console where it can be seen clearly and is within reach. Do
not place in a location where it interferes with seeing other information, controls, or
the field. Looking at the screen for too long while operating the vehicle can cause a
crash.
Attaching the Battery
Avoid contact with cables that carry high current. Connect the Outback S-Lite power
cables to a stable 12-volt power supply.
Operating S-Lite
To avoid serious injury or death be prepared to respond to field conditions. Do not
become distracted by other tasks.
Always pay attention to the task of driving the vehicle and stay seated while the
vehicle is in motion.
SLite_UG_D1.book Page 3 Monday, December 23, 2013 2:14 PM
To Next Page
Loading...