Indicators and Displays: Menu Map:
Outback S-Lite
TM
Quick Reference Guide
Part Number: 875-0195-000 Rev B1
GPS and DGPS Signal Indicators:
The unit automatically searches for available signals.
Red light = no available signal
Yellow light = GPS signal acquired
Green light = DGPS signal acquired
Differential Corrections (DGPS)
The differential correction type is selected from two
GPS applications (SBAS or e-Dif
TM
) loaded into the
receiver. You can change the correction type via the
CORRECTION TYPE item in the Service menu.
NOTE: After turning power on to the Outback S-Lite,
the system may need to track GPS satellites for 10
minutes before differential corrections can be
generated. The vehicle may be moving or stationary
during this time.
While tracking, the Outback
S-Lite will show the GPS light
and will display the number of
satellites being tracked.
Once the unit is finished tracking,
the DGPS light will show and
READY will be displayed.
Headland Indicator:
Headland Alert = crossing previously applied area.
Main Run Screen Display
GPS signal quality
(3-4 bars typical with
SBAS
Display message
Press the MENU button. The SETUP MENU screen
appears.
Use the UP and DOWN ARROW buttons to navigate
the menus.
Press the ENTER button to make selections.
Below is a list of all Outback S-Lite menu items.
For more information on the Outback S-Lite refer to
the Outback S-Lite User Guide.
6HWXS0HQX
%ULJKWQHVV
6ZDWK:LGWK
6HQVLWLYLW\ 0HGLXP
3HULPHWHU6HWXS 5LJKW
'LDJQRVWLFV !
6HUYLFH0HQX !
'LDJQRVWLFV
&RUUHFWLRQ7\SH 6%$6
6DWV 7UN 8VHLQ&DO
67'(9 IW
+'23
'LII$JH VHFV
%LW5DWH(UURU
*366RIWZDUH 9HU
$SS6RIWZDUH 9HU
6HULDO1XPEHU
0HPRU\ KU)UHH
6HUYLFH0HQX
&RUUHFWLRQ7\SH 6%$6
6%$66DWHOOLWH $872
10($3RUW6HWXS !
8QLWRI0HDVXUH )HHW
/DQJXDJH (QJOLVK
5HVHW'HIDXOWV !
10($3RUW6HWXS
10($3RUW6HWXS
10($3RUW%DXG
**$ +]
*// 2II
97* +]
50& 2II
*6$ 2II
='$ 2II
S-Lite Console:
What the buttons do:
- Access the System menu
- Navigate menus or toggle between Run
Screen views
- Activate Contour Guidance mode
- Activate Straight Guidance mode
- Stop guidance/stop logging data
- Make selection
To Next Page
Need help?
General