Outdoor Essentials ELEVATED GARDEN PLANTER User Manual

ELEVATED GARDEN PLANTER
INSTALLATION INSTRUCTIONS
©2016 Universal Forest Products, Inc. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc. All rights reserved.
68956 U.S. Hwy 131, White Pigeon, MI 49099 616.365.4201 8902_7/16
www.outdooressentialproducts.com
STEP 1 STEP 2
•
Kit contents
• 2 – 32 in. "A1"
leg components
• 2 – 32 in. "A2"
leg components
• 2 – 32 in. "B1"
leg components
• 2 – 32 in. "B2"
leg components
• 2 – 10-1/2 in. x 46-1/4 in.
side assemblies
• 2 – 10-1/2 in. x 20-3/4 in.
end assemblies
• 1 – 22-1/2 in. x 46-1/2 in.
bottom tray
• 4 – 1x4 bottom supports
• 40 – Screws
Tools needed
• Drill
• #2 Phillips drill bit
Assemble one “A1/B1” leg and one “A2/B2” leg by fastening
together through the predrilled holes (fig. 1).
Note: Do not assemble all four legs. Two legs will need to
remain unassembled for later steps.
Attach one leg on each side assembly (fig. 2).
Side Assembly
Side AssemblyA1
A2
B1
B2
Ledger
•
•
•
Ledger
•
A1
B1
B2
A2
fig. 1
fig. 2

Outdoor Essentials ELEVATED GARDEN PLANTER Specifications

General

Brand	Outdoor Essentials
Model	ELEVATED GARDEN PLANTER
Category	Lawn and Garden Equipment
Language	English

Summary

Step 1: Assemble First Set of Legs

Assemble A1/B1 and A2/B2 Legs

Assemble one "A1/B1" leg and one "A2/B2" leg by fastening together through the predrilled holes.

Step 2: Attach Legs to Side Assemblies

Connect Legs to Side Assemblies

Attach one leg on each side assembly by fastening through the predrilled holes.

Step 3: Attach End Assembly

Install End Assembly Between Legs

Place legs approx. 21" apart, slide end assembly between, and fasten.

Step 4: Attach Remaining Legs

Secure Top Legs to Side Assemblies

Attach "A1" and "A2" to side assemblies with 3/4" overhang through predrilled holes.

Step 5: Install Bottom Supports and Tray

Add Bottom Supports and Plastic Tray

Place four bottom supports and slide plastic tray over them.

Step 6: Complete Leg Assembly

Attach Remaining Legs to End Assembly

Attach "B1" and "B2" to end assembly and connect "A1" to "B1", "A2" to "B2".