PICNIC TABLE
ASSEMBLY INSTRUCTIONS
Insert four (4) 3-1/2" carriage bolts into the predrilled seat
crossmember (E). Position so that the bolt heads are on the
ground and the threads are exposed. Make sure the beveled edge
of the seat crossmember is facing down. Position the legs (D) so
that the predrilled holes align with the bolts and the tops of the
legs are level and straight. Add the washers and secure with a
wing nuts. Repeat step for the second leg assembly (fig. 1).
Place the preassembled table top (A) upside down and position
the preassembled leg frame, making sure the seat crossmember
is facing out.
Step 2
Step 1
Items you will need
• Drill
• 1/8" drill bit
Contents
• 1 – Preassembled table top (A)
• 2 – Preassembled seats (B)
• 2 – 2"x 3"x 23-1/2" diagonal braces (C)
• 4 – Predrilled table legs (D)
• 2 – Predrilled seat crossmembers (E)
• 8 – 3-1/2" carriage bolts with nuts and washers
• 36 – 2-1/2" wood screws
fig. 2
3-1/2" Carriage bolt
2-1/2" wood screw / predrilled holes
2-1/2" Wood screw
Diagonal brace
Beveled edge
Lowe’sTable2.ai
• Tape measure
• Adjustable wrench
A
B
C
D
E
(4) 3-1/2" carriage
bolts through
crossmember
and legs
HDTable.ai
fig. 1
Optional
To maintain the appearance of your table, apply two coats of
water repellent to wood components every two years.
2-1/2" Wood screw
Vis à bois 2-1/2"
Diagonal brace
Entretoise
2-1/2" wood screw
Diagonal brace
fig. 3
©2017 Universal Forest Products, Inc. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc.
Assembled in the USA with imported fasteners. All rights reserved.
2801 East Beltline NE, Grand Rapids, MI 49525 | 800.598.9663 | 9333_4/17
OutdoorEssentialProducts.com
To Next Page
Need help?
General