14
Standby Mode and ON Mode
Standby Mode - Selected (through iDISPLAY-Settings Application)
Add-On Push Button: The Push Button will start flashing and the unit will initially
show a black screen (power saving mode). When the Flashing Push Button is pressed
it will start playing content (will play content located in folder 0, see “Playing
Content” on page 15 for explanation).
Add-On Motion Sensor: The unit will show a black screen (power saving mode) until
the Motion Sensor senses motion. When motion is detected, it will activate and start
playing content (will play content located in folder 0, see “Playing Content” on page
15 for explanation).
ON Mode (default mode) - Selected (in iDISPLAY-Settings)
The Tablet plays content immediately (will play content located in folder 0,
see ‘Playing Content for explanation).
During Play
While the Tablet is playing content, it behaves as follows depending on which mode
the user selected in the iDISPLAY-Settings application.
Standby Mode - Selected (in iDISPLAY-Settings)
When playing video or image files, the Tablet plays all the content (in Folder 0,
see “Playing Content” on page 15 for explanation) one time and then goes back to
Standby mode (power saving black screen) and reverts control to either the optional
Push Button or Motion Sensor Add-Ons if one is connected.
If an application (APK) is running, the Tablet will wait until there has been no user
interaction for over 3 minutes and then goes back to Standby mode (power saving
black screen) and reverts control to either the optional Flashing Push Button or
Motion Sensor add-ons.
ON Mode (default mode)
The tablet plays all the content in Folder 0 repeatedly in an endless loop (see ‘Playing
Content on page 15 for explanation).
NOTE: There is no visible option for this in iDISPLAY-Settings. By turning o the
Standby Mode, the Tablet automatically reverts to ON Mode.
To Next Page
Loading...