Outform iDISPLAY - STANDBY MODE AND ON MODE

13
Standby Mode and ON Mode
STANDBY MODE AND ON MODE
Standby mode enables you to extend battery life by setting the Tablet to only display
content when needed. This mode is typically used when the Tablet is running only on
a battery, to extend battery life.
Standby mode is used in conjunction with the iDISPLAY Add-On Push Button and
Motion Sensor Accessories that can plug into the left and right side of the Tablet
when in the landscape position. When in standby, the Tablet displays a black screen
and waits for the Push Button or Motion Sensor to activate it to start playing
content. For more information on these special purpose add-ons,
please visit www.outform.com/idisplay-add-ons.html.
ON Mode (default) When not in Standby Mode, the iDISPLAY Tablet is in ON mode.
In this mode it plays a content playlist contained in folder 0, in a continuous loop
until the iDISPLAY Tablet is turned o.
Standby Mode or On Mode can be selected in iDISPLAY-Settings application
The iDISPLAY-Settings application allows the user to select whether the unit will be
in ON Mode or Standby Mode when it powers up. The default setting is ON Mode. As
mentioned before, the Standby Mode is intended to be used with one of the optional
Add-On Accessories, such as the Push Button or Motion Sensor accessories.
This setting selection is in addition to the Standby slider on the back of the unit. This
setting is intended to be used on those displays that are built into a kiosk, when you
have no access to the controls on the rear of the unit.
The following describes how the Tablet operates in each of these modes.
When Turning on the Tablet
When you power on the iDISPLAY Tablet by pressing the On/O button at the back
of the Tablet, the Tablet behaves as follows depending on which mode the user
selected in the iDISPLAY-Settings application.