21
iDISPLAY Tablet Accessories
This section describes the mounting attachments and other accessories that can be
connected to the iDISPLAY Tablet.
Printer
The iDISPLAY Tablet supports standard Android OS4.X printer drivers. This enables
the connection of a printer that can be used by the applications (apks) that you load,
such as coupon printer.
Add-On Push Button
The flashing Add-On Push Button accessory can be attached on either the left or
right side of the iDISPLAY Tablet. No cables are required and it is secured with two
screws on the back of the tablet. The purpose of the flashing Push Button accessory
is to activate the iDISPLAY Tablet to revert from Power Saving Standby Mode when
the button is pressed, as explained on page 14.
Add-On Motion Sensor
The Add-On Motion Sensor accessory can be attached on either the left or right side
of the iDISPLAY Tablet. No cables are required and it is secured with two screws on
the back of the tablet. The purpose of the Motion Sensor Accessory is to wake the
iDISPLAY Tablet up from its Power Saving Standby Mode when Motion is detected
near the device, as explained on page 14.
Mounting Options (VESA)
The following are some of the mounting options available from iDISPLAY.
Fixed Wall Bracket
Rotating Wall Bracket
Fixed Shelf Bracket
Rotating Shelf Bracket
Table Bracket
Counter Display
Floor Display
Please visit http://www.outform.com/tablet-7-inch-tech-spec.html to download the
latest product specification sheets for the iDISPLAY Tablet 7”.
iDISPLAY TABLET ACCESSORIES
To Next Page
Loading...