Overhead door CodeDodger User Manual

Overhead Door Company
of Cedar Rapids & Iowa city
800-393-9976
Always disconnect operator from door before programming
to avoid injury to yourself or the operator
OVERHEAD DOOR • CodeDodger/Intellicode
Reset Keypad:
1. Slide cover on keypad just enough to press "PROG" and "8" at the same time. While
depressing these keys, raise the cover all the way. This erases old code. Release buttons
and close cover.
2. Open cover fully. Press numbers "3", "5", "7", and "PROG" - red light will blink slowly.
3. Put in your new pin number (1 to 8 digits) and press "PROG" - red light will blink faster.
4. Close keypad cover.
5. Got to motor unit in garage. Press "LEARN" button on back of operator - this is a small,
round, black button located about an inch away from the antennae.
6. Go back to the keypad and slide keypad cover open fully.
7. Enter pin number and press "SEND", "SEND", "SEND", "SEND".
To Change Pin # Without Resetting Keypad:
1. Open cover fully.
2. Enter OLD pin number and press "PROG".
3. Enter the NEW pin number and press "PROG".
4. Close keypad cover.
OVERHEAD DOOR • CodeDodger/Intellicode
Multiple Door Instructions
Follow the above instructions fully before attempting to program a CodeDodger
Wireless Keypad
for multiple door operation. When the keypad is working properly for a single door, follow the

Overhead door CodeDodger Specifications

General

Brand	Overhead door
Model	CodeDodger
Category	Remote Control
Language	English

Summary

Reset Keypad

Keypad Reset Procedure

Steps to erase old codes, set new PIN, and sync with the operator by pressing PROG, SEND, and LEARN buttons.

Change Pin # Without Resetting Keypad

PIN Change Procedure

Steps to change the keypad PIN by entering the old PIN, then the new PIN, and confirming with PROG.

Multiple Door Instructions

Multiple Door Programming Steps

Program keypad for 2 or 3 doors by entering PIN, total doors, and syncing with operator LEARN buttons.