Clear CodeDodger® and Fixed Remotes on a Single Door (Three Door Mode
Only)
1. Press and hold the door button for the door you wish to clear remotes from.
The LED will turn on solid.
2. After approximately 20 seconds the LED will ash three times and turn
o. Release the door button. All CodeDodger and xed code remotes have
been cleared from the door.
Clear All Remotes (Three Door Mode or Single Door Open/Close/Stop Mode)
1. Press and hold all three door buttons simultaneously. After 20 seconds
all three LEDs will ash three times and turn o. Release the buttons. All
CodeDodger® and xed code remotes have been cleared from memory for
all doors. Note that during the 20 second button press all three LEDs will
turn o briey twice then back on. The frequency mode will also be reset to
315/390MHz.
PROGRAMMING RECEIVER
To Next Page
Loading...
