J
Jill JohnsonAug 13, 2025
What to do if my Overhead door Odyssey 1000 7030H starts down, then stops and goes back up?
- MMatthew SchwartzAug 13, 2025
If this is a new installation, check the door arm position. You should also check if the limits are properly set and ensure the Safe-T-Beam® red LED is not flashing. Inspect the Safe-T-Beam® system for any beam obstruction or misalignment. Also, check the garage door for any binding. If the opener will not close, you can force it to close by pressing and holding the wall console button until the door is completely closed. Finally, check for interference from adjacent Safe-T-Beam® units.