10400359-004 ©2011-2014 Overland Storage, Inc. Page 1 of 5
*10400359-004*
SnapServer
™
DX2 / SnapScale
™
X2 Node
Add-on/Spare DIMM Instructions
This document describes how to either add a additional DIMM
(Dual In-line Memory Module) to or remove and replace an
existing DIMM from a SnapServer DX2 or SnapScale X2 node
from Overland Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working with
the unit.
AVERTISSEMENT:Pour réduire le risque de choc électrique ou
endommagement de l'équipement, retirez toujours les cordons
électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
IMPORTANT: Using DIMMs that are not supplied by
Overland Storage will void your warranty. Overland
Storage DIMMs have been tested and verified to operate
properly with Overland appliances. Failure to use qualified
DIMMs may impact data availably or lead to data loss.
Register the Add-on DIMM
NOTE: If you are only replacing an existing DIMM, skip to the next
section, “Prepare the Unit.”
When adding a DIMM to your server, you must first register it
to activate the warranty. Technical and warranty support are
not available until this is done:
1. Go to the Overland Storage website
(http://www.overlandstorage.com/).
2.
Select
Service & Support > My Products
.
3. At the Site Login, enter your e-mail address and
password, and click
GO
.
4. Click the
Manage Products
button.
5. From the Product Selector drop-down list, select the DX2
or X2 in which you are installing the DIMM.
6. Click
Add a Component
.
7. Enter the DIMM information.
8. Click
Save & Exit
.
IMPORTANT: Your warranty certificate will be emailed to you.
Follow the instructions included to complete the process.
Enter
Enter
*10400359-004*
To Next Page
Need help?
General
