Overland Storage SnapServer XSD 40 User Manual

10400570-001 ©2014 Overland Storage, Inc. Page 1 of 4
*10400570001*
SnapServer
®
XSD 40
Chassis Replacement Instructions
This document describes how to swap out the chassis of a
SnapServer XSD 40 from Overland Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Prepare the Unit
Power Off and Disconnect Cables
1. Briefly press the Power button on the front.
2. When all the front LEDs are off, disconnect the power
cord.
3. Disconnect all the cables from the unit.
Remove the Drives
NOTE: Do not remove the disk drives from their carriers. Doing so
voids the drive warranty.
1. Slide the release button to the right. The latch on the
front of the carrier will release and the handle will extend.
2. Using the handle, pull the carrier out.
3. Set the carrier on a secure surface.
4. Repeat Steps 1–3 for each remaining carrier.
Power
Cables
Press Right
Pull Carrier

Overland Storage SnapServer XSD 40 Specifications

General

Brand	Overland Storage
Model	SnapServer XSD 40
Category	Storage
Language	English