10400592-001 ©2014 Overland Storage, Inc. Page 1 of 4
*10400592001*
SnapServer
®
XSD 40
Add-on/Spare DIMM Instructions
This document describes how to add an additional or remove
and replace an existing DIMM (Dual In-line Memory Module)
in a SnapServer XSD 40 from Overland Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
WARNUNG: Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Register the Add-on DIMM
NOTE: If you are only replacing an existing DIMM, skip ahead to
the next section, “Prepare the Unit.”
When adding a second DIMM to your unit, you must first
register it to activate the warranty. Technical and warranty
support are not available until this is done:
1. Go to the Overland Storage website
http://www.overlandstorage.com/
2.
Select
Service & Support > My Products
.
3. At the Site Login
, enter your e-mail address and
password, and click
GO.
4. Click the
Manage Products button.
5. From the Product Selector drop-down list, select the
XSD 40 in which you are installing the extra DIMM.
6. Click
Add a Component.
7. Enter the DIMM information.
8. Click
Save & Exit.
IMPORTANT: Your warranty certificate will be emailed to you.
Follow the instructions included in the email to complete the
registration process.
5325301507-XSD 40 s/n: 0247
To Next Page
Need help?
General
