Overlander VSRmini - 3 Warnings and Safety Notes

3. Warnings and Safety notes
IMPORTANT! Please follow these instructions for maximum safety, otherwise
the charger and/or battery could be badly damaged and may lead to fire,
explosion, injury or property loss.
- Never leave the charger unattended when it is connected to its power supply.
- If any malfunction is observed, terminate the process immediately and refer to the manual.
- Keep the charger away from dust, damp, humidity, rain, heat, direct sunshine and vibration.
- The circuit of the unit is designed to be powered by 100-240V AC only.
Voltage level: 1.2V/cell
Recommended fast charge current: 1C~2C depends on
the performance of cell discharge voltage cut of
f level
0.85V/cell (NiCd), 1.0V/cell (NiMH)
Voltage level:3.6V/cell
Max. charge voltage: 4.1V/cell
Recommended fast charge current: 1C or less
Min. discharge voltage cut off level: 2.5V/cell or higher
Voltage level: 3.7V/cell
Max. charge voltage: 4.2V/cell
Recommended fast charge current: 1C or less
Min. discharge voltage cut off level: 3.0V/cell or higher
Voltage level: 3.8V/cell
Max. charge voltage: 4.3V / 4.35V / 4.4V/cell
Recommended fast charge current: 1C or less
Min. discharge voltage cut off level: 3.0V/cell
Ensure maximum charge voltage is set. This would
usually be 4.35V but please check instructions with the
LiHV battery. Never charge standard LiPo battery on
LiHV setting.
Voltage level:3.3V/cell
Max. charge voltage:3.6V/cell
Recommended fast charge current: 4C or less
Discharge voltage cut off level:2.0V/cell or higher
Voltage level:2.0V/cell (Lead-acid)
Max. charge voltage:2.46V/cell
Recommended fast charge current:0.4C or less
Min. discharge voltage cut off level:1.50V/cell or higher
NiCd / NiMH
LiIon
LiPo
LiHV
LiFe
Pb
- 3 -