To Next Page

To Previous Page

Device Setup

OWC Mercury Helios 3S

7. Slide the inner-chassis back into the outer-

enclosure as shown above.

8. When the inner-chassis is fully seated into the

outer-enclosure, tighten the thumbscrews on

the rear panel. Press each screw in toward

the enclosure, then twist clockwise while still

applying pressure. Keep twisting until you feel

increased resistance.

This completes the assembly process.

Questions and Answers:

Need help?

Do you have a question about the OWC MERCURY HELIOS 3S and is the answer not in the manual?

OWC MERCURY HELIOS 3S Specifications

General