To Next Page

To Previous Page

Device Setup

OWC Mercury Helios 3S

DEVICE SETUP

2.1 Assembly

Please follow the steps below to install a PCIe card in the Mercury Helios 3S.

The Mercury Helios 3S and your PCIe card are static-sensitive devices. They are susceptible to invisible

damage if not protected during installation. For proper grounding, we recommend using a grounding strap.

Work in a clean, static-free area, and avoid wearing clothing that retains static charges. Please visit this URL for

more information: www.owcdigital.com/anti-static

1. Loosen the thumbscrews on the rear panel

until they spin freely. These are captive

screws; they cannot be removed.

2. Set the Mercury Helios 3S on its side, then

grip the front grill and pull the inner-chassis

so that it slides out of the outer-enclosure.

3. Set the inner chassis on a working surface,

with the rear ports oriented to the left, as

shown.

Questions and Answers:

Need help?

Do you have a question about the OWC MERCURY HELIOS 3S and is the answer not in the manual?

OWC MERCURY HELIOS 3S Specifications

General