Need help?Do you have a question about the Oxygen 8 VENTUM Series and is the answer not in the manual?
Explains the meaning of warning and caution symbols used throughout the manual.
Instructions for safely removing the unit from its packaging and locating components.
Steps to disassemble the fan section from the core section for installation.
Table detailing fan and core weights for different Ventum models.
Details on mounting the unit horizontally using inner and outer brackets.
Step-by-step instructions for assembling and installing the hanging brackets.
Guidance on installing additional accessories with the unit.
Information on installing coupled accessories with ceiling-mounted units.
How to support ceiling-hung decoupled accessories using brackets and threaded rod.
Information on connecting and installing external sensors.
Details on installing the supply air temperature sensor (TTH-6202).
Instructions for installing the pressure sensor in the duct.
Procedure for installing the CO2/VOC sensor and connecting its tubes.
Guide for installing the combined temperature and humidity sensor.
Table with detailed electrical specifications for different models.
Wiring diagram and instructions for single-phase electrical hook-up.
Wiring diagram and instructions for three-phase electrical hook-up.
Diagram showing single-phase fan wiring connections.
Diagram showing three-phase fan wiring connections.
Wiring diagram for 240V single-phase Ventum unit, configuration S1.
Wiring diagram for 240V single-phase Ventum unit, configuration S2.
Wiring diagram for three-phase Ventum unit, configuration S1.
Wiring diagram for three-phase Ventum unit, configuration S2.
Field wiring diagram for DX coil with EKE.
Field wiring for DX coil with electric reheat and EKE.
Field wiring for electric pre-heat, DX coil, electric reheat, EKE.
Field wiring for electric pre-heat, DX coil, and EKE.
Wiring diagram for damper actuators.
Wiring diagram for electric reheat functionality.
Wiring for electric pre-heat and electric reheat.
Wiring diagram for electric preheat configuration.
Wiring for hydronic cooling water coil.
Wiring diagram for humidity control systems.
Wiring diagram for combi coil applications.
Wiring diagram for hydronic pre-heat systems.
Wiring for occupancy mode control.
Wiring diagram for hydronic re-heat systems.
Wiring diagram for fire alarm integration.
Wiring for DX coil, hydronic coil, EKE, and bypass.
Wiring for CO2 control and external bypass.
General| Model | Oxygen 8 VENTUM Series |
|---|---|
| Type | Case Fan |
| Fan diameter | 120 mm |
| Fan height | 25 mm |
| Connector | 4-Pin PWM |
| Material | Plastic |
| Color | Black |
| Warranty | 2 years |
| Voltage | 12 V |
| Motor Speed | 800 - 1800 RPM |
| Air Delivery | 55 CFM |
To Next Page
