For proper installation of the motor Castor follow the steps as follows.
1 - Open the packaging and check that the drive has not been damaged
due to the transportation, etc..
2 - Make sure the gate is perfectly horizontal and moves freely.
3 - Release the motor as shown in the procedure for emergency release.
4 - Fix the pillar on the side of the door, the plate A, the following
allowances to be respected as in FIG 1 and Table 1.
5 - Install the motor on the plate A and secure it with the pin and the
grub screw provided.
6 - With the door closed, slide the mounting pin F and the mechanical
stopper D to the end of run. Fix the mounting pin F to the plate B to
determine the fixing position of the plate on the leaf.
7 - Use the references taken to secure the support plate B to the leaf.
Fasten the motor with the pin F to the plate. Check the position and fix
the stopper D by tightening the screw G.
8 - Open the door in the desired open position and fix the limit switch E
in place by tightening the screw G.
9 - Repeat the steps with the other gate leaf.
10 - Carry out the wiring and fitting of safety devices.
11 - Position the cover cap C on the release pin. FIG 2
To Previous Page
Loading...