CAUTION: THIS FAN HAS A POLARIZED PLUG (ONE BLADE
IS WIDER THAN THE OTHER). TO REDUCE THE RISK OF
ELECTRICAL SHOCK, THIS PLUG IS INTENED TO FIT IN A
POLARIZED OUTLET ONLY ONE WAY. MATCH THE WIDE
BLADE OF THE PLUG TO THE WIDE SLOT OF THE OUTLET.
FULLY INSERT. IF THE PLUG DOES NOT FIT FULLY IN THE
OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT,
CONTACT A QUALIFIED ELECTRICIAN. DO NOT ATTEMPT TO
BYPASS THIS SAFETY FEATURE.
NOTE: THIS FAN IS EQUIPPED WITH A FUSE. ALWAYS UNPLUG
THE FAN BEFORE REPLACING FUSES. IF THIS FAN LOSES
POWER AND YOU SUSPECT THE FUSE IN THE PLUG HAS
BLOWN, UNPLUG THE FAN, THEN SLIDE THE FUSE DOOR
FOUND ON THE SIDE OF THE PLUG TO THE OPEN POSITION.
SLIDE THE FUSE DOOR OUTWARD UNTIL THE BLOWN FUSE
IS FULLY VISIBLE. REMOVE THE BLOWN FUSE AND SNAP THE
REPLACEMENT FUSE INTO PLACE. FULLY CLOSE THE FUSE
DOOR. ONLY REPLACE WITH A FUSE RATED AT 2.5 AMPS,
125 VOLTS.
9
To Next Page
Loading...
