Ozito BLV-2401 - MAINTENANCE

13
MAINTENANCE
• There are no user serviceable parts in the blower vac; if a fault is suspected or the
supply cord requires replacement, return the blower vac to a power tool repairer.
• Keep air intake clean and air vents free from debris to avoid overheating the motor.
• Do not use cleaning agents to clean the platic parts of the blower vac. A mild
detergent on a damp cloth is recommended. Water must never come into contact
with the blower vac.
• If the blower vac vibrates adnormally, stop motor immediately. Abnormal vibration
usually indicates a machanical problem continued operation could lead to injury or
damage.
• No lubricaton is necessary as the motor is equipped with lifetime-lubrication bearings.
• Keep the ventilation vents of the blower vac clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the blower vac housing to ensure it is free from
all dust particles which may have built-up. Build up of dust particles may cause the
blower vac to overheat and fail.
• If the enclosure of the blower vac requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the blower vac; never immerse any
part of the blower vac into liquid.
• When not in use, the blower vac should be stored in a dry, frost free location not
within the reach of children.
Note: Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or mishandling or mistreatment of the tool.
This tool is designed for DIY use - use in commercial or industrial environments will void
the warranty.
WARNING! Always make sure that the blower vac is switched OFF and
unplugged. Wait until the impellor has stopped before the blower vac is
serviced, cleaned or maintenance is performed.