7
• The longest life and best performance can be obtained if the battery pack is
charged when the air temperature is between 18 - 24ºC. Do not charge the
battery pack in an air temperature below 10ºC or above 40ºC. This is
important and will prevent damage to the battery pack.
• Do not incinerate the battery pack even if it is seriously damaged or is
completely worn out. The battery can explode in a fire.
• Never attempt to open the battery pack for any reason. If the plastic housing
of the battery pack breaks or cracks, immediately discontinue use and do not
recharge.
• During charging, the battery must be placed in a well ventilated area
•
Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an electric shock.
• Do not use the drill in wet or damp conditions.
• Always keep the work area free of tripping hazards.
• When using the drill always ensure you are wearing protective safety equipment
including safety glasses/goggles, ear muffs, dust mask and other protective
clothing including gloves and apron.
• Always check the work piece before operation and remove any obstructions such
as nails, staples, screws, string, rags, cloths and other debris.
• Always use clamps or a vice to hold down and secure the work piece.
• Before drilling ensure there is a suitable gap below the work piece to prevent the
drill bit from touching any obstacles.
• Before drilling holes or screwing into walls ensure that you are not breaking into
any electricity, gas or water supply line, etc.
• Never change the direction of the chuck rotation while the tool is still running.
Ensure the chuck has come to a complete stop before changing the rotation of
the drill.
• Do not lay the tool down unless the tool is switched off and the chuck has come
to a complete stop.
• Keep hands and other body parts well away from the work area whilst the tool is in
use.
• Keep hand well away from the under side of the work piece during use.
• Do not use your hand to remove any dust, chips or other waste while the tool
is in use.
• Do not touch the drill bit after operation. The bit will be HOT and burn.
BATTERY AND CHARGER SAFETY WARNINGS
!
!
DRILL SAFETY WARNINGS! ADDITIONAL SAFETY RULES
!
!
To Next Page
Loading...
