ASSEMBLY
7
OPERATION
Cord retainer
When attaching an extension cord to the Trimmer, hook the end of the extension cord
into the cord retainer built into the rear of the Trimmer’s housing. Using the retainer
prevents accidental disconnection of the trimmer and extension cords plug and socket.
Always be sure to route the cord away from the work area to prevent it from coming
near the blade. Decide how you want to route the cord before starting work.
Start trimming at the point nearest the electrical outlet, then move away while working.
The cable will then be pulled through the area which has already been cut and thus
reduce the danger of itself being cut.
Switching On
For your safety this Hedge Trimmer is designed with a two hand safety switch. If you
only squeeze one switch the Hedge Trimmer will not be activated. To turn the Hedge
Trimmer ON squeeze both switches at the same time.
Switching Off
To turn the Hedge Trimmer OFF, simply release either switch.
Blade Brake
The Hedge Trimmer is fitted with a motor brake which will almost instantaneously stop
the cutting blade.
When the unit is switched off and the motor brake operates there may be some
sparking (or flashing) occurring in the area of the upper motor ventilation slots.
This is normal and will not damage the machine.
Trimming Instructions
1. Extension cord
. Always keep the extension cord behind the Trimmer and away from
the trimming operation. Never drape it over a hedge being trimmed. If you cut or
damage the cord, unplug it at the electrical outlet immediately. It must be repaired
by an electrician or a power tool repairer before being used again.
2. Working position. Maintain proper footing and balance and do not overreach.
Wear safety goggles, non-slip footwear and rubber gloves when trimming. Hold
the tool firmly in both hands and turn the tool ON. Always hold the trimmer with
one hand on the body handle and one hand on the front handle. Never hold the
tool by the blade guard.
To Next Page
Loading...
