ADDITIONAL SAFETY INSTRUCTIONS FOR PLANERS
6
!
!
WARNING: Use of this tool can generate dust containing chemicals
known to cause cancer, birth defects or other reproductive harm.
Use appropriate respiratory protection.
• Be sure to read the instruction manual thoroughly before using this tool.
• Be sure the voltage agrees with specific data on the nameplate.
• Be sure the switch is in OFF position before connecting tool to the
power supply.
• Be sure to switch OFF immediately if the tool is jammed in work.
• Be sure the tool is disconnected from power source when cleaning or
making adjustments to the tool.
• Be sure the tool is properly held and set for correct use before turning
switch to ON.
• Be sure to use specified replacement parts only.
• Be sure to maintain tool with care. Follow instructions for lubricating
and changing accessories.
• Be sure to store tool in a clean dry place after disconnecting from
power source.
• Keep air vents unobstructed for proper motor cooling.
•
DO NOT lay tool down on shoe when the blades are exposed.
This can chip the blades.
• Keep side dust extraction port unobstructed at all times.
• Never reach under the tool for any reason unless it is turned off and
UNPLUGGED. BLADES ARE EXPOSED AND EXTREMELY SHARP.
• Use this tool for working with wood and wood products only.
• Never operate without securely holding the front handle.
• Always operate planer with two hands.
• Planer blades ar
e extremely sharp – Handle with great care.
CAUTION: Some wood contains preservatives such as copper
chromium arsenate (CCA) which can be toxic. When sanding,
drilling, or cutting these materials extra care should be taken
to avoid inhalation and minimise skin contact.
To Next Page
Loading...
