Ozito PBL-030 - Adjusting Blower Speed; Throttle Trigger Operation; Throttle Lever Adjustment

1
4. ADJUSTING THE SPEED
2 Ensure the choke lever is in
the open position “ “.
2 Set the on/off switch to the off
position “o“.
Note: If the engine does not start up even after several attempts,
follow the steps in “Cold Starting”.
x10
1 Set the blower on a
hard, level surface
and the on/off switch
to the On position “
“.
1 To increase the
speed of the blower,
squeeze the throttle
trigger.
1 To increase the set
speed of the blower,
rotate the throttle
lever forward.
2 To decrease the
speed of the blower,
release the throttle
trigger.
2 To decrease the set
speed of the blower,
rotate the throttle
lever backward.
The blower has 2 speed adjustments, the throttle trigger allows fast
speeds changes whereas the throttle lever will maintain a speed once
set.
1 Allow the blower to
slow by releasing the
throttle trigger and
setting the throttle
lever to the slow
position.
4 Hold the blower
rmly and pull out
the recoil starter until
you feel resistance.
Pull rmly on the
recoil starter until the
engine starts.
x10
INCREASE
SPEED
DECREASE
SPEED
INCREASE
SPEED
DECREASE
SPEED
Warm Starting
Throttle Trigger
Throttle Lever
Stopping the Blower