DESCRIPTION OF SYMBOLS
SPARE PARTS
Read instructions
V
Volts Hz Hertz
~ Alternating current W Watts
/min
Revolutions or
reciprocation per minute
no No load speed
Warning
Do not expose to rain
Disconnect and discontinue use should the power cord be damaged
93
dB
Decibel (noise) rating
Beware of debris being
ejected from the shredder
Keep by standers away
Wear eye protection
Wear safety gloves
Sound power level
Danger - Rotating blades. Keep hands and feet out
of openings while machine is running
Ø
Do not expose to rain
Diameter
N
Direction control switch - Reverse
Cutting adjustment knob - Rotating clockwise Ò Ð Ówill move
the metal plate closer to the cutting head, rotating
anti-clockwise Ò+Ò will move the metal plate away from the
cutting head.
- Neutral
- Feed
CAUTION! ONLY CHANGE THE DIRECTION OF
ROTATION AFTER THE SHREDDER HAS COME TO
A COMPLETE STOP AND THE CUTTER HEAD HAS
STOPPED ROTATING.
Problem Remedy
The motor does
not run
Set the direction control switch to position “0” and
press the reset button.
Turn the direction control switch to either the feed
or reverse position and turn on the shredder.
Possible power failure, check the power supply/
cord and house fuse box.
The material to
be shredded
is not pulling
through the unit
The cutting blade is running in reverse. Turn off
the shredder and change the direction control
switch to the feed position.
The material is jammed in the roller blade. Set the
control switch to the “O” position and switch the
shredder on. Pull the material from the hopper.
Carefully refeed thick branched material making
sure the blade does not immediately grasp the
pre-cut notches again.
The rolling cutter head is blocked. Set the
direction switch to the reverse position and switch
the shredder on. The cutter head will now run
backwards and release the blocked material.
Material is not
being shredded
sufciently
Ensure the metal plate is correctly adjusted
in relation to the rolling cutter head. Refer to
the “Prior to operation” section for detailed
instructions.
Tripping circuit
breaker
Use shorter extension lead.
Maximum length 25m.
TROUBLESHOOTING
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landll and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your local
council authority for recycling advice.
To Next Page
Loading...
