Ozone BV1 - Page 13

11
SPEED SYSTEM
Alightweightintegratedspeed-lineisincludedasstandard.Thespeedsystemisalreadyinstalledbythefactorybutifyoueverneedto
replaceit,ensureitisroutedasfollows.
Routethefreeendofoneofthelinesdownthroughthesmallreinforcedslitfoundonthesidepanelof
theharness.
Pass the line through the Ronstan pulley and then the ring ensuring the pulley is
nottwisted.Ensurethatthelinesruncleanlythroughthepulleysandpassonthe
insideofallstructuralwebbingstraps.Double-checkthelineshavenotinadvertently
wrappedaroundanyofthestructuralwebbingstrapsbeforeattachingthemtothe
bar.Thebarcanthenbejoinedwiththebungeesattachedtothefootplate
Onceintheair,andwhenitissafetodoso,checkthatyoucanplaceyourfootonthebareasilyandthatthesystemoperatessmoothly
allthewaytofullspeed.
IMPORTANT: The speed bar lines must be of equal length, ensure they are not too short as this will
inadvertently activate the speed system when under tension in the air. Always double-check lengths and
symmetry whilst on the ground before ying.