Ozone Rush 5 - B-Line Stall; Spiral Dives

EN
21
20
Step 8.IfusingtheSaucissePack,carefully
zipitupwithouttrappinganymaterial.
Step 9.TurntheSaucisseonitssideandmaketherst
foldjustaftertheLEreinforcements.Donotfoldtheplastic
reinforcements,use3or4foldsaroundtheLE.
IMPORTANT: Do NOT lay the wing
at on the ground before packing the
glider, this will cause abrasion damage
to the top surface as you pull the glider
towards the middle. ALWAYS pack from
a mushroom or lift the wing off the
ground when gathering the wing and
grouping the leading edge.
IMPORTANT: Do not fold the glider in the centre, you
will bend the plastics, instead pack the wing with a full
concertina method from tip to tip before packing into the
stuff sac.
If using a Saucisse pack go to Step 8.
Step 7.Nowplacethefoldedwingintothestuffsack.
Step 4.Grouptogetherthemiddle/trailing
edgeofthewingbysortingthefoldsnear
theB,CandDtabs.
Step 6.Foldthewingwith3or4foldswhilstbeing
carefultonotcrushtheLE.
Step 5.OncetheLEandrearofthewinghave
beensorted,turnthewholewingonitsside.