Warranty & funcon!
Extraconofextrapowerdirectlyfromthe
baeriesisnotpermied.
Allconnectedequipmentmustbeconnected
asshownintheinstrucons.
In the case of welding or any other type
of work that may damage electronics
or baeries, these must always be
disconnected before work commences!
Warranty
AllP-LIGHT®models arecoveredbya one-
year product warranty which comes into
forceonthepurchasedate(mustbeveried).
I.e. When InnoNet AB has been given the
opportunity to determine valid damage
coveredbythewarranty,
all or parts of P-LIGHT® will be replaced,
but no compensaon will be paid for e.g.
workshopcosts,downme,etc.
If warranty repairs are requested, InnoNet
ABorthepurchaselocaon/distributormust
alwaysbecontactedimmediatelyforadvice.
Anycostsarisingwithoutthepermissionof
InnoNetABwillnotbeapproved!
IMPORTANT!As the baerieslosecapacity
over me (as all chargeable baeries do),
itisnecessarytocarryoutabaerytestso
as to know when to replace them. If you
neglect to do this, your P-LIGHT® may not
becapableofremainingonforthemeyou
wereexpecngwhenyouparkedthetrailer
inashortstaypark,oritmaynotbecapable
ofsupplyingpowertohydraulicequipment,
etc.asrequired.Inotherwords:replacethe
baeriesingoodme!
IMPORTANT: P-LIGHT® holds type approval
to ECE No. 10. For this to be valid, the
incoming cable connected to terminals 3-7
must be ed through the installed ferrite
core,asillustrated(notapplicabletoMidi).
Manufacturer
InnoNetAB-Olvägen7-SE-34250Vislanda
Phone+46472-48383
www.innonet.se
Org.nr556684-9385
Support
Phone + 46 472-483 93
E-mail: support@innonet.se
Internet: support.p-light.com
www.p-light.com since 2000
10
Important!
P-LIGHTisregisteredtrademarkownedby
InnoNetAB