Assembly
STEP 5
Gently pull the recoil start handle up to the
recoil retaining loop.
STEP 6
Using the hooks on the grass bag, hook the
grass bag over the corresponding plastic
moulding at the rear of the lawn mower.
STEP 7
Lower the rear discharge flap until it rests on
the grass collector.
20
STEP 8
Set the cutting height to maximum. The height
is automatically adjusted for all wheels.
STEP 9
Fill the lawnmower with oil and fuel.
Instructions on how to do this are on the next
page.
STEP 10
Make sure you attach the cables and adjust
the OPC and drive cables. Instructions on how
to do this are on pages 21-23.
To Next Page
